Is Replacement Light Strip of LED Light Strip Kit part # LC674282 Available

Question

Question:

Can I purchase just the rope light or do I need to purchase the entire system?

asked by: John C

0

Expert Reply:

We have just the replacement light strip of the LED Light Strip Kit part # LC674282 that you referenced with the part # LC423331.

expert reply by: Jameson C

0

Answer 1

The Lippert 15-Foot LED Fabric Light Kit for Solera RV Awnings #LC674282 is intended to install by sliding into the light cord by the coach sidewall, under the awning, that is sewn into the awning fabric. If you prefer an LED light strip that…

view full answer...

Answer 2

Yes the LED Fabric Light Kit with Switch/Plate for Solera RV Awning #LC674283 does fit the Solera awning you have on your 2020 Forest River Sabre. Thanks for adding the picture as that made it very easy to determine!

view full answer...

Answer 3

I do have some options for you to add lights to your awning. If you have a Lippert Solera Awning then there may be a light track on the coach under the awning and in which case you would just use the LED Fabric Light Kit like part #LC674282 and…

view full answer...

Answer 4

I went out to our warehouse to take a look at the Replacement LED Light Strip #LC423331 that you referenced. The light strip itself is extremely thin so it's going to pretty much fit inside any housing that's designed for this purpose. I also…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

When choosing the slider you want to measure the outside front of box width including the flange. Then you need to select a slider that extends a minimum of 2-1/2 inches beyond each side of the box width. For example, the Black Solera Slider…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

I can end this debate for you real fast! Trailer tires, which will have an ST in front of the size, should always be inflated to the maximum psi indicated on the tire. Trailer tires usually do not have a recommended and maximum psi indication so I am…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Is Replacement Light Strip of LED Light Strip Kit part # LC674282 Available

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching