Is It Normal For Grease To Push Past The O-Ring On The Bearing Buddy Bearing Protectors?
Question:
I have had these or ones like them for years buy when i put pump in grease and then drive for a while it seema like a lot of the grease pushes back out from around the o ring. Is this normal?
asked by: Micah
0
Expert Reply:
It is normal for grease to expand and can push out through the O-ring on the Bearing Buddy # BB2441T-SS.
When you drive with the trailer, heat is created on the bearings as well as transferred into the hub from the brakes. As the parts heat up the steel and grease will expand. If your hub is packed full of grease it has to have somewhere to go so it pushes itself out through the O-ring.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Bearing Buddy Bearing Protectors - Model 2441T-SS - Threaded - Stainless Steel (Pair)
- Trailer Bearings Races Seals Caps
- Caps
- Bearing Protector Grease Cap
- 2.321 Inch
- Bearing Buddy
more information >
Continue Researching
- Q&A: Options For Replacing A Tie Down Turbo Lube 48394 Clear Oil Bath Cap
- Q&A: What Grease Cap Fits The Easy Grease Trailer Hub and Drum Assembly # AKHD-655-6-G-EZ-K?
- Q&A: Replacement Stainless Steel Kodiak Trailer Brake Kit For 6,000LB Axle With 6 On 5-1/2 Bolt Pattern
- Article: Cargo Tie-Down Methods
- Q&A: Can 215-60-8 Trailer Tires be Replaced with 215/65-10 Tires on Snowmobile Trailer
- Q&A: Correct Replacement Oil Seal 225255UC for Ranger Boat Trailer
- Q&A: Replacement Seal for National Seal or Timken Seal 472920
- Q&A: Parts Needed For Installing Stainless Steel Disc Brakes On a 6,000LB Single Axle Trailer
- Article: Most Popular Wheel Bearings
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Calculating Portable Generator Power Needs
- Article: Trailer Tire Sizing
- Article: Printable Trailer Bolt Hole Pattern Template