How To Find Correct Replacement Dexter Drive-In Wheel Stud
Question:
Recently had studs break on boat trailer. They look to be dexter as they have a Dinch on the end. they are total length of @2 1/4, drive in section is @9/16, wheel hub section is@1/2inch and remainder is the threaded section @1inch long. Not sure is #7232 is correct.
asked by: Rob B
0
Expert Reply:
In order to choose the correct replacement wheel stud you'll need to take some very specific measurements of the spline and shaft. These measurements are listed on each product page for the replacement stud such as the Replacement Drive-In Trailer Hub Wheel Stud part # 7-232.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Replacement Drive-In Trailer Hub Wheel Stud - 5/8"-18 x 2-3/4" Long - Quantity 1
- Accessories and Parts
- Boat Trailer Wheels
- Trailer Hubs and Drums
- Trailer Tires and Wheels
- Wheel Studs
- 5/8 Inch Diameter
- Drive-In Stud
- 2-3/4 Inch Long
- Dexter
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Towing a Trailer with Electric Brakes with a Semi Tractor with Air Brakes
- Q&A: Replacement Inner Member Assembly for UFP A 60 Surge Brake Coupler
- Article: How to Use a Roof Rack (Like a Boss)
- Q&A: Brake Controller Wiring for Ford E-450 Motorhome
- Q&A: Size of WeatherTech Side Window Air Deflectors # WT82476 for 2014 Chrysler Town and Country
- Q&A: Is Adhesive Tape Used When Installing WeatherTech Air Deflectors On 2015 Dodge Grand Caravan
- Q&A: Replacement for Atwood 70254 RV Landing Gear Switch
- Q&A: Recommended Trailer for Two Titan Propel 12 Kayaks
- Article: Trailer Lighting Requirements
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Best Bike Racks for Electric Bikes
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Adapters for Towing a 5th Wheel Trailer with a Gooseneck Hitch