Is Drilling Required with Husky Rear Mud Flaps, Part # HL57101, on a 2009 Jeep Grand Cherokee Laredo
Question:
My Jeep has plastic fasteners that attach the fender to the inner fender well. Do Husky mud flaps use these pre-drilled holes for fastening rear mud flaps? Could you send an electronic copy of the installation instructions prior to ordering?
asked by: Larry P
Expert Reply:
The Husky Liners Mud Flaps for the 2009 Jeep Grand Cherokee, part # HL57101, do require drilling for installation. (Please note that these mud flaps fit the 2009 Laredo without the 5.7L Hemi).
Tools required for installation include a drill, 1/8-inch drill bit, hammer, center punch, and a short Phillips screwdriver. Written installation instructions have been forwarded.
If you are also interested in the front mud flaps, they are part # HL56101, and they too require drilling for installation.
Product Page this Question was Asked From
Husky Liners Custom Molded Mud Flaps - Rear Pair
- Mud Flaps
- Custom Fit
- Rear Pair
- Wheel Well Mount
- Custom Width
- Plastic
- Husky Liners
more information >
Continue Researching
- Q&A: Recommended Floor Mats for 2017 Coachmen Leprechaun on Ford E-450
- Q&A: Floor Mats for 1997 Ford E450 Class C Motorhome
- Q&A: Determining The Correct Size Landing Gear SnapPad Size
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Does Truck with 6-1/2 ft bed Have to Use Slider Hitch for Turning Clearance with Fifth Wheel Hitch
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Is The Curt C96JR Tail Light Kit Compatible With A Brake Buddy Brake System?
- Article: Trailer Tire Sizing
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: My Trailer Hitch Doesn't Fit