Tip for Installing Replacement Jet Nozzle for SewerSolution Macerator System

Question:

I had the sewer pump cracked after just 2 uses, stored in RV so was think heat might have gotten to it. Ordered a new pump but how the heck do I get it inserted into the hose, I have tried leaving it in sun to soften the hose, tried hair dryer. How can I get it inserted?

asked by: Barbara C

Helpful Expert Reply:

Make sure the band clamp of the # SS01 is totally loosened and slid back off of where it would need to slip over the nozzle of the # 278-2204. You can put some dish soap on the nozzle as well to help it slide into the hose which is a tight fit. Try that and see if that helps.

expert reply by: Jameson C