Trailer Hub is Sitting Too Far Back on the Spindle
Question:
I put hub on in back on it is 1/4 past spindle other side of trailer is flush. Is it possible to put on to far? Hope i didnt smash anything
asked by: Sean I
0
Expert Reply:
It actually sounds like the hub that is sitting flush isn't pushed on all the way. The area the seal sits should stop the bearing from moving too far, so I suggest pushing that one on further and they should then match each other.
expert reply by:
Lazer S
0
Product Page this Question was Asked From
CE Smith Trailer Idler Hub Assembly w/ Case for 2.7K Axles - 5 on 4-1/2 - Galvanized - Pre-Greased
- Trailer Hubs and Drums
- Hub
- Pre-Greased
- Standard
- L44649
- L44649
- For 2700 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 13 Inch Wheel
- 14 Inch Wheel
- CE Smith
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How To Tell If Bearing Buddy Has Enough Grease
- Shop: Bearing Buddy Bearing Protectors - Model 1781 - Chrome Plated (Pair)
- Video: Rhino-Rack Sunseeker Awning Review
- Shop: CE Smith Trailer Idler Hub Assembly w/ Case for 2.5K Axles - 5 on 4-1/2 - Galvanized - Pre-Greased
- Shop: Bearing Buddy Bearing Protectors - Model 1980A w/ Auto Check - Chrome Plated (Pair)
- Q&A: How Much Grease Should be Added to the Bearing Buddy Bearings
- Shop: Rhino-Rack Sunseeker Awning - Roof Rack Mount - Bolt On - 7' Long x 6' 10" Wide
- Search Results: ce13311
- Search Results: 12192tb
- Search Results: cotter pin
- Search Results: hub kit
- Search Results: ce13315
- Shop: CE Smith Trailer Hub Assembly w/ Carrying Case for 2,700-lb Axles - 5 on 4-1/2 - Pre-Greased
- Shop: CE Smith Trailer Idler Hub Assembly w/ Case for 2.7K Axles - 5 on 4-1/2 - Galvanized - Pre-Greased
- Shop: Single Axle Trailer Fender for Enclosed Trailer - Ribbed Steel - 13" to 14" Wheels - Qty 1
- Q&A: How to Determine Correct Replacement Hub For Jet Ski Trailer
- Q&A: Determining Correct Replacement Hub For Karavan Single Jet Ski Trailer W/ Single Axle and 13 Wheels
- Q&A: Replacement Pre-Greased Hubs that Use L44649 Inner and Outer Bearings
- Q&A: Recommended Hub Assembly for L44649 Inner/Outer Bearings and Grease Seal with 1.25 Inner Diameter
- Q&A: What Grease Is Used With the CE Smith Trailer Idler Hub Assemblies?
- Search Results: l44649
- Search Results: 145 80 r12