Storage Cover for Travel Trailer With Two Entry Doors

Question

Question:

we have an adco cover that is literally falling apart. we have a 25 ft 2011 keystone cougar 25 ft plus bumper, so probally 27 ft with tongue. it has two entry doors on the side, one in the front section and one in the back. Are there 3 zippers to allow access to either door? we often access our trailer in the winter when it it covered and unzip the front or rear section, depending upon which section of the trailer we need to access as the tip outs are in when covered. can you tell me if your current models have this flexibility or if only the center section has a zipper.?

asked by: Sandy L

0

Expert Reply:

The Adco SFS AquaShed Cover for Travel Trailer, # 290-52243 that you refer to has one large area in the center of the street side cover. Please note the attached image.

When measuring for a trailer cover you want to measure from the front of the trailer box, not the tongue, to the rear including anything that is attached to the rear. This will include a spare or a ladder at the farthest edge at the rear of the trailer, measure the length, width, and height of the body.

I suggest you consider, after verifying the length needed, the Classic Accessories PolyPro III Deluxe Travel Trailer Cover, # 052963734638 as this as a wider opening and may better suit your needs of two doors.

expert reply by: Michael R

0

Measure
(click to enlarge)

290-52238_27_1000
(click to enlarge)

Answer 1

I was able to narrow down your 2019 Heartland Mallard M32 to having the Lippert stabilizer jacks. They will be either the 5-1/2" to 5-5/8" Pads #SN68FR or the 5-3/4" to 6" Pads #SN99FR. You will need to measure…

view full answer...

Answer 2

For your Wildwood 230 BHXL the trailer cover part #052963734638 that you referenced would work well as it is designed for trailer 24-27 feet in length which works perfectly with yours that measures 25 foot 10 inch. This is a great cover for all…

view full answer...

Answer 3

I have yet to hear of any problems with a Classic Accessories cover such as #052963733631 causing any abrasions, marring, or damage in general to a trailer. This particular cover has air vents to reduce the amount of wind that can get trapped under…

view full answer...

Answer 4

Camper covers are manufactured to have some wiggle room to make it easier to put on your trailer and to make sure they will accommodate a variety of trailers. Since the frame of your trailer is 24 feet and your camper itself itself is 22 feet, not…

view full answer...

Answer 5

Most likely what the manufacturer is talking about when they say 26 feet is the length of the trailer including the trailer tongue. When choosing the correct cover for your 2017 Keystone Outback 220URB travel trailer you will want to measure from…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

Hey Brad, thanks a bunch for going ahead and getting all those measurements in advance. Based on the measurements you've given, the TorkLift GlowStep Revolution Uprising Steps w/ Booster Step #TL52SR will work perfect for your coach. These steps…

view full answer...

Answer 8

Hey John, the Tire Linc One Control part #LC37VR would be a great option to allow you to monitor the Wrangler's tire pressure while it's being flat towed. This comes with a signal repeater to help with longer setups like what you have as…

view full answer...

Storage Cover for Travel Trailer With Two Entry Doors

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching