Lippert LC358590 Ground Control 3.0 Out of Stroke Error
Question:
Out of stroke error Do I have to hook up to my truck to fix this error?
asked by: Greg
Expert Reply:
The 'Out of Stroke' error means that one or more jacks have been over-extended. If they will not retract using the touchpad, then you'll need to manually retract them using the manual override located under the black protective cap on top of each jack.
To clear the error, extend all of the jacks in the system at least 6 inches. Then press and hold the retract button until the jacks start to retract. All of the jacks should fully retract and the error should be cleared.
If you keep getting the error or can't manually retract the jacks, then they've been internally damaged and would need replacement.
For front legs, the proper replacement is # LC305340. For the right rear, use # LC344792 or # LC305339 for the left rear.
Products Referenced in This Question
Replacement 24-1/2" Left Rear Leg - Lippert Ground Control 3.0 Electric Leveling System
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Follow Leg
- Lippert
more information >
Replacement Lead Leg for Lippert Components Ground Control 3.0 Electric Leveling System - Qty 1
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Driver Leg
- Lippert
more information >
Replacement 24-1/2" Right Rear Leg - Lippert Ground Control 3.0 Electric Leveling System
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Follow Leg
- Lippert
more information >
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Is The Pad For The Replacement 22-1/2" Legs For The Ground Control 3.0 Welded Or Pinned In Place
- Q&A: Wiring Installation for 5th Wheel Landing Gear Switch
- Q&A: Wiring Guide for Installing 5th Wheel Landing Gear Motor Switch
- Q&A: Replacing Electric Landing Gear on 5th Wheel Trailer with Auto-Leveling System
- Q&A: Which Lippert Ground Control 3.0 System Is Recommended for a 37' Fifth Wheel
- Q&A: Drawing Schematic of Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0
- Article: How to Raise Your Travel Trailer Height
- Q&A: Replacement Control Panel and Circuit Board for LCI Electronic Leveling System
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: How to Level Your Fifth Wheel in 3 Simple Steps (Manual or Auto-Level)
- Article: Gooseneck to 5th Wheel Adapters
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Double-Eye Trailer Suspension System Review