Recommended Hub for a 2016 Yacht Club WC112 Trailer
Question:
I need hub assembly + bearings kit and dust cap for my 2016 Yacht Club WC112. VIN # 4H1001319H0511965 THANK YOU
asked by: Tammy
Expert Reply:
You will need to confirm your bearing numbers and wheel bolt pattern to make sure the correct parts are ordered. Unfortunately we do not have a way to look up the VIN on a trailer, but if you contact the manufacturer of the trailer, they should be able to tell you exactly which inner and outer bearings you have and the bolt pattern of your wheels.
If for some reason they can't, you will need to pull off one of the hubs. Once it is off, you will need to measure the inner diameters of both your inner and outer bearing. This should be done with calipers as it does need to be as precise as possible.
To get your bolt pattern, you will need to measure from the center of one lug bolt to the center of the lug bolt right next to it (picture included). The following measurements will tell you which bolt pattern you have:
If D = 2-5/8", then the bolt pattern is 5 on 4-1/2"
If D = 2-3/4", then the bolt pattern is 5 on 4-3/4"
If D = 3", then the bolt pattern is 5 on 5"
If D = 3-1/4", then the bolt pattern is 5 on 5-1/2"
If you have a 4 bolt pattern, you can skip that part though.
Once you have the bolt pattern and the inner and outer bearings, we can definitely get you the correct hub assembly.
Product Page this Question was Asked From
#84 E-Z Lube Spindle w/ Brake Flange for 3,500-lb Trailer Axle - 1-3/4" Diameter
- Trailer Spindles
- EZ Lube Spindle
- 1-3/4 Inch Diameter
- Round
- For 3500 lb Axle
- TruRyde
more information >
Continue Researching
- Shop: MORryde Suspension Upgrade Kit for Tandem Axle Trailers - 3-1/8" Long Shackle Straps
- Article: Most Popular Wheel Bearings
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Flange Bolt Pattern and Distance From Flange To Rear Of #84 E-Z Lube Spindle TRU74FR
- Q&A: Which is Better an EZ Lube Spindle or a Bearing Buddy Setup
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Hub and Spindle for TDE 11033 Hub
- Q&A: Replacement Hub/Rotor and Bearings for Tie Down Engineering TDE46245
- Q&A: Replacement # 84 Spindle Recommendation to Replace a Trailer Spindle
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Replacement Hub and Rotor Assembly for 2023 Shoreland'r Boat Trailer with 3,000 lb Weight Rating
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Replacing Spindle of Dexter 3,500 lb Axle Due to Wear