Can C-800 Replacement Klauber Motor be Tested with Battery
Question:
Is there anyway to test the motor to see if it will spin in one direction without hooking it up to the trailer?
asked by: Travis
0
Expert Reply:
The C-800 Replacement Klauber Motor for Standard Lippert Electric Stabilizer Jacks # LC138445 only has two wires on it so you'd just need to run the black wire to the positive side of your battery and the white to ground and it would run at that point.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
C-800 Replacement Klauber Motor for Standard Lippert Electric Stabilizer Jacks
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Motor
- Lippert
more information >
Continue Researching
- Q&A: Correct Gen-Y Pin Box to Replace a MORryde RPB72-1716
- Q&A: Replacement Stabilizer Jack Need for Lippert Model 113407
- Q&A: Replacement Motor for LCI Power Stabilizer Jack Model 1917771
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: Most Popular Wheel Bearings
- Q&A: Recommended Replacement for Atwood GC10A-4E RV Water Heater
- Q&A: Solution for Keeping RV Furrion Refrigerator Doors Closed when Travelling
- Q&A: Replacement Motor for Lippert Components PSX2 Electric RV Stabilizers
- Q&A: Reese Goose Box Recommendation to Replace MORryde Pin Box SPB72-1621LD
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Bleed Your Trailer Surge Brakes
- Article: How to Measure a Trailer Axle
- Article: RV Cell Boosters, How Do They Work?