Will the Curt Hitch # 13028 Fit a 1978 Chevy K10 with a Factory Bumper?
Question:
Will Curt part # 13028 trailer hitch fit a 78 Chevy K10 with a factory step bumper, if so is drilling required?
asked by: Gary T
1
Helpful Expert Reply:
Yes, the Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" # 13028 will fit a 1978 Chevy K10 with a factory bumper. The hitch comes with a complete hardware kit that only requires a bolt-on installation without drilling.
expert reply by:
Bob C
1
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 600 lbs TW
- 6000 lbs GTW
- 10000 lbs WD GTW
- 2 Inch Hitch
- 1000 lbs WD TW
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Hub for 2013 Wildwood 26TBSS Hub Drum with AL-KO 8700
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement Trailer Jack Recommendation for Dutton-Lainson Jack on Ranger Trailer
- Q&A: Troubleshooting Kodiak 225 Trailer Brake System that Keeps Breaking Calipers In Half
- Article: How to Choose the Right Trailer Hitch Class
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Can You Replace A GE Air Conditioner Be Replaced With An Advent A/C?
- Q&A: Recommended RV Exterior Ladder for 22 Ft Thor Four Winds RV
- Q&A: Troubleshooting A Clunking Noise Between A Fifth Wheel Hitch And Base Rails While Towing
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Article: Big Truck Big RV
- Article: My Trailer Hitch Doesn't Fit
- Article: Pintle-Hitches
- Article: Best Ladder Racks