How is JR Products 37210905 Replacement Interior Latch Handle Held In Place
Question:
any tips on removing the old broken handle?.. seems to have a pin through it that doesnt take a hex wrench... ??
asked by: Marty M
0
Expert Reply:
The # 37210905 replacement handle secures using a set screw that's tightened/loosened with an Allen wrench, which is pretty typical. If you could send me a photo of the broken handle with a tight focus on the set screw, I might be able to identify the fastener holding it on for you.
If worst comes to worst, you can always drill out the set screw at which point the old handle should come right off.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Replacement Interior L-Shaped Handle
- Trailer Door Latch
- Latches
- L-Handle Latch
- Steel
- Non-Locking
- 3-1/2 Inch Long
- Fits 5/16 Inch Wide Shaft
- 1 Inch Wide
- JR Products
more information >
Continue Researching
- Q&A: Dimensions And Operation Of Non-Locking Steel Flush Door Latch # N3980
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Can a Trailer Ride With the Tongue at an Upward or Downward Angle
- Q&A: Alternative Replacement for a Bargman L-200 Door Lock Set
- Q&A: Will the Polar Heady Duty Camp Action Door Lock Work to Latch Horse Trailer Dutch Doors to Ramp
- Q&A: Dimensions of Keepers on Lockable Door Latch
- Q&A: Recommended Handle Latch Kit for Barn Door on Dump Trailer
- Q&A: Replacement Latch For Living Quarters Horse Trailer Door
- Article: Trailer Maintenance Schedule
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps