How Does Ball Bracket Install on Both Sides of Ball Mount for Two Friction Sway Control Units
Question:
Do you have anything to accommodate dual sway control on a ball mount that can handle 7700# gtw? I dont need load distribution but would like dual sway control without custom fabrication.
asked by: Sean S
0
Expert Reply:
If you are going to do a dual friction sway control setup on your trailer you'd have to have two tabs welded to your ball mount with the part # 3442 and you'd be set. There isn't a different solution that does not require welding.
expert reply by:
Jameson C
0
Products Referenced in This Question
Replacement Sway Control Tab for Weight Distribution System - Weld On
- Accessories and Parts
- Weight Distribution Hitch
- Sway Control Parts
- Tab
- Draw-Tite
more information >
Product Page this Question was Asked From
Reese Sway-Control Bracket for 2" Ball Mounts - Class III and IV
- Accessories and Parts
- Weight Distribution Hitch
- Adapters
- Sway Control Parts
- Brackets
- Reese
more information >
Continue Researching
- Q&A: Recommended Trimax Trailer Wheel Chock and Lock for 175/80R/13 Tires
- Article: How to Measure for Trailer Hitch Drop
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Q&A: Parts Needed to Add Brake Controller to 2024 Toyota Sienna Platinum
- Article: RV Roof Types: What Type of Roof Does My RV Have?
- Q&A: Can Sway Control be Used on a Trailer without Using Weight Distribution
- Q&A: Can The Furrion Vision S Prewired System Be Switched to Us Voyager WiSight Camera System?
- Q&A: Recommended Sway Control for 1800 lbs 13 Foot Scamp Travel Trailer
- Article: Steel vs. Aluminum Ball Mounts
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Q&A: Replacement Motor For A Thompson Saginaw Part No. 7831293
- Q&A: How to Determine if a Vehicle has a Class I or Class II Trailer Hitch
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?