What Size Socket to Tighten Bolts on Reese Weight Distribution Head with Trunnion Bars
Question:
WHAT SIZE SOCKET AND WRENCH DO I NEED TO TIGHTEN THE HEAD TO THE SHANK? THANK YOU
asked by: ERIC M
0
Expert Reply:
The Replacement Head for Reese Weight Distribution System - Trunnion Bar # RP58167 uses a 3/4" bolt with a 1-1/8" nut, so you'll need a 1-1/8" socket to tighten the head to the shank.
expert reply by:
Erik B
0
Product Page this Question was Asked From
Replacement Head for Reese Weight Distribution System - Trunnion Bar
- Accessories and Parts
- Weight Distribution Hitch
- Head
- Trunnion Bar
- Reese
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Reese Replacement Clips for Weight Distribution Uplift Brackets (Qty 2)
- Q&A: Will Reese Weight Distribution System Fit on Draw TIte Shank and Vice Versa
- Q&A: Reese WD Hitch Identification Based on Trunnion Bars
- Q&A: Does Mounting Position of Weight Distribution Shank Used Affect Weight Capacity
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Replacement Head for Reese Weight Distribution System
- Q&A: Recommended Grease to Use for a Reese SC Weight Distribution System
- Q&A: Is Equal-i-zer Shank EQ90-02-4900 Same as 90-02-4325
- Q&A: 1,200 lb Tongue Weight Spring Bars for Pro Series RB2 Weight Distribution Head
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: How to Measure for Trailer Hitch Drop
- Article: The Best Towing Mirrors
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How to Install a Weight Distribution Hitch (With Pictures & Video)
- Article: How to Back Up a Trailer