Inside Diameter of Bulldog Handle BD500203
Question:
Would you have the inside diameter of the opening on this crank please? I have an Atwood 12V jack that is missing the crank and if the dimensions are correct this one will work... The stud OD on the Atwood is 1/2inch so this crank will have to fit that dim. Any assistance you may provide will be greatly appreciated.
asked by: Tom
0
Expert Reply:
The opening of the # BD500203 is 1/2 inch like you said you'd need.
expert reply by:
Jameson C
0
Inner Diameter
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Replacement Manual Override Crank for Bulldog Powered-Drive Trailer Jacks
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Handles and Cranks
- Sidewind
- Bulldog
more information >
Continue Researching
- Q&A: Availability of Replacement Propane Supply Hose Flex Tech H72812-72
- Q&A: Replacement Converter For Parallax 7355 Power Center Converter
- Q&A: Replacement Motor for Slide Out Motor with Part # 8532-18HT
- Q&A: Dimensions of the Opening on Replacement Manual Override Crank # BD500203
- Q&A: Troubleshooting Lippert Trailer Tongue Jack that the Light Will Come on But Will Not Extend/Retract
- Q&A: Direct Replacement for Carrier Air V RV Air Conditioner
- Q&A: Reese Goose Box Recommendation to Replace MORryde Pin Box SPB72-1621LD
- Article: Best Camper Jacks
- Article: Trailer Wiring Diagrams
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Jacks
- Article: Which Hitches are Made in the USA
- Article: How to Mount a Truck Bed Camper
- Article: 7 Common Questions Everyone Has About Trailer Tires