Hardware Needed to Install Pack 'Em PK-6 Utility Trailer String Trimmer Rack
Question:
What bolt length is recommended for these? And should I get washers or lock washers?
asked by: Manny
0
Expert Reply:
The length of mounting hardware needed for the Pack 'Em # PK-6 trimmer rak will be completely dependent on how and to what you mount the racks. Using 3/8 inch grade 8 bolts, nuts and lock washers is recommended by the manufacturer.
I've linked to an installation video that you might find helpful.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Pack'Em Trimmer Rack for Utility Trailers
- Trimmer Racks
- Utility Trailer
- 3 Trimmers
- Pre-Drilled Holes
- Locks Included
- PackEm
more information >
Continue Researching
- Q&A: Best Brake Controller for a 2023 Chevy Silverado
- Q&A: Will Pack'Em Rack for Open Utility Trailers Fit 2' high Sides on Trailer
- Q&A: Replacement Grease Seal for Transcom TCM22333TBN
- Q&A: Will Blower Rack for Utility Trailers Be Compatible with 12 Inch High Mesh Sides
- Q&A: What is the Distance Between Mounting Holes on the Pack'Em Trimmer Rack # PK-6
- Q&A: Are the Accessories Included with the Pack'Em Rack Part # PK-6-OP1
- Q&A: What is the Height of the PackEm Rack for Open Utility Trailers
- Article: Trailer Hitch Receiver Sizes
- Article: Best Boat Accessories
- Article: Top Weight Distribution Hitches for a Buttery Smooth Ride
- Article: Types of Bumpers
- Article: Slipper Spring Trailer Suspension System Review
- Article: Double-Eye Trailer Suspension System Review
- Article: Trailer Tire Sizing