Ground Clearance of Curt Trailer Hitch Receiver on 2017 Ram ProMaster City
Question:
Hi! Im curious how much clearance I would loose using the Curt Trailer Hitch Receiver - Custom Fit - Class III - 2inch - C13215inch on my 2017 Ram Promaster City? Thanks!
asked by: Ben
Expert Reply:
When we installed the Curt Trailer Hitch Receiver # C13215 on a 2018 Ram ProMaster City, we measured it to have 9" of clearance to the ground. This measurement may differ with your 2017 Ram ProMaster City as depending on cargo loading, that will vary the suspension.
It will hang approximately 3-4" to the base of the hitch below your factory bumper cover.
If you are towing with your ProMaster you will need the Curt Wiring Harness # C56270. This will give you your lighting circuit for trailer towing. The Brackets # 18136 and # 18144 will provide a clean mount for the 4-way harness.
Products Referenced in This Question
- Accessories and Parts
- Trailer Wiring
- Mounting Hardware
- Brackets
- 4 Round
- 5 Round
- 6 Round
- Tow Ready
more information >
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Shop: Air Lift 1000 Air Helper Springs for Coil Springs - Rear
- Shop: Suspension Enhancement
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Q&A: Why are the Hitches for a 2015 Ram ProMaster City Class III 2 inch Hitches
- Q&A: Replacement for Atwood 61101 Brake Actuator
- Article: Pintle-Hitches
- Q&A: Difference Between Curt and etrailer Trailer Hitch Receivers for 2020 Chevy Colorado
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Can Hot Lead From Wiring Harness be Run Inside Vehicle
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Correct Torque Specs for Lug Nuts with 10" Kodiak Disc Brake Kit Installed
- Article: Performance Chips and Modules
- Article: Brake Controller Installation on a Ford Full-Size Van
- Q&A: Fit of Draw-Tite Class III 76050 Trailer Hitch On Extended Model 2020 Ram ProMaster 3500
- Q&A: Bypassing Factory Brake Controller and Installing Aftermarket Model on 2018 GMC Sierra 3500