Availability Of LED Circuit Board Light With 906/921/194 Base

Question

Question:

DO YOU HAVE THESE BULBS??? SEE PHOTO ATTACHED

asked by: Jesse

0

Expert Reply:

I have an option that will work as a replacement, but we do not have a bulb that has the exact amount of LEDs as the bulb in your picture.

We do have the 906/921/194 LED Light Bulb in Warm White # DI76VR, Cool White # DI86VR, or Daylight White # DG65601VP that will work as they use the same 906/921/195 base as the bulb in your picture.

I included a few video reviews for you to take a look at.

expert reply by: Samuel C

0

Customer LED Circuit Board Light Bulb
(click to enlarge)

Answer 1

The proper extension for your setup would be the one that allows you to have clearance of your hitch mounted accessory and also allows you to still be able to pull the steps down. If the receiver tube sticks out past the camper too far then you will…

view full answer...

Answer 2

Based on the 12,400-lb base weight of your 2016 Reflections 357BHS you should have the Equa-Flex Cushioned Equalizer #LC279688 which works with 6K to 8K axles. The wet bolt to use is part #LC126238; you will need 7 for each side of the trailer, so 14…

view full answer...

Answer 3

Yes, the Optronics LED RV Interior Double Dome Light #RVILL34 will work with a dimmer. We have asked the manufacturer, Optronics, about this exact issue before and they have confirmed for us that this light is able to be dimmed so it'll be great…

view full answer...

Answer 4

The width of the LED light part #DI76VR is 1-3/8 inches and the overall height is 2 inches which is from edge of wedge to the screw hole.

view full answer...

Answer 5

What plugs into the fitting of the Empire Shower Valve #EM84FR is actually a flexible spout part #EM94FR.

view full answer...

Answer 6

There is a solution for you, but the lift kits you referred to such as #K71-725-02 will not work with welded on torsion axles. The best option is for you to simply remove your torsion axles and use the Timbren Axle-Less Trailer Suspension System…

view full answer...

Answer 7

There will be an option for a lift kit for your 2021 Forest River R-Pod 171, though that depends on the configuration of the torsion axle. We know that these trailers use the Lippert torsion axles, though you'll need to take a look at see if…

view full answer...

Answer 8

We do indeed carry Optronics products. The number you provided is a DOT reference number, and does not denote the part number of the lamp or the lens. However we had a picture sent in once from a guy of the housing of the light he needed a lens for…

view full answer...

Answer 9

If you want to convert to a 5 on 5 bolt pattern the only option is for 3,500 lb axles. Assuming you have #L68149 inner and #L44649 outer bearings you could use #AKIHUB-550-35-EZ-K for an idler hub or #AKHD-550-35-EZ-K for a hub and drum assembly. If…

view full answer...

Availability Of LED Circuit Board Light With 906/921/194 Base

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching