What Mounting Hardware Is Needed For Lippert Electric trailer Jack LC285318?
Question:
What is the grade and the diameter of the bolt that holds the electric Jack to the trailer frame.
asked by: Al
Helpful Expert Reply:
The hardware used to mount the Lippert Electric Trailer Jack with Footplate - A-Frame - 18" Lift - 3,500 lbs - Black # LC285318 is really dependent on the coupler of your trailer as it is typically threaded, but sometimes are drilled out for using a nut and bolt.
The only requirements are that the hardware is at least 3/8" diameter and at least grade 5. If your current hardware is in good shape you can reuse it, if not you will need to source the hardware from a local hardware store.
I included a video of the # LC285318 for you to take a look at.
Product Page this Question was Asked From
Lippert Electric Trailer Jack with Footplate - A-Frame - 18" Lift - 3,500 lbs - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- Bolt-On
- 1 Jack
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Weight Distribution Recommendation for a 2024 Jayco Flight 284BHS
- Q&A: Replacement 3500-lb Electric Tongue Jack for Lippert 1817941
- Q&A: Hitch Extender For 2-1/2 Inch Hitch For Weight Distribution
- Q&A: Lowest-Profile A-Frame Trailer Jack For Tailgate Clearance
- Q&A: Replacement For A-Frame Tongue Jack on Lippert Electric Ground Control TT
- Article: RV Pre-Departure Checklist
- Q&A: Replacement Toggle Switch For Lippert Power Stance Trailer Jack
- Article: Trailer Wiring Diagrams
- Q&A: Correct Replacement for an Atwood Water Heater GC6AA-9E
- Article: Trailer Jacks
- Article: How (and Where) to Connect an RV Propane Grill
- Article: Most Popular Wheel Bearings
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How to Measure for Trailer Hitch Drop