Replacement Antenna for Voyager WAOM562 Backup Camera System

Question

Question:

I have a Voyager back up system Model WAOM562 and I need a antenna for this system as its broken. What number do I need to order, Thank you

asked by: Robert A

0

Expert Reply:

To replace the antenna on the Voyager WAOM562 Observation/Backup camera system you'll need the # PXXHD0006301R, which has been confirmed with the manufacturer.

expert reply by: Erik B

0

Answer 1

The correct replacement camera antenna for the Voyager WAOM562 Backup Camera System is the Replacement Wireless Antenna for Voyager Backup Camera System part #PXXHD0006301R which fits the Voyager WVCMS130AP Camera.

view full answer...

Answer 2

According to ASA Electronics, the #PXXHD0006301R is the correct replacement antenna for their Voyager WAOM562 Observation/Back Up Camera System.

view full answer...

Answer 3

Yes, we do have the power wiring piece for the Voyager Camera WVCMS130AP that you referenced. It is found as part #PSVCWVCMS130AP on our site. I confirmed with my contact at Voyager that this is the correct part you need.

view full answer...

Answer 4

My first thoughts on your Voyager WiSight Wireless System, #WVOS541, are, there is an issue getting a strong wireless signal. You've checked power to the monitor but what about the camera and antennae, please verify that too. If you are getting…

view full answer...

Answer 5

Sounds like you have a system like the Voyager RV Observation Camera System w/ Monitor and Mount #VOM43HDCL1B. I attached our review video of this system which explains the different features, wiring harnesses, and shows how the system looks…

view full answer...

Answer 6

From what I was able to find on your Voyager WV0S511 (discontinued) there were two different style of cameras that were used. One of which used a straight antenna like the Replacement Wireless Antenna for Voyager Backup Camera System #PXXHD0006301R…

view full answer...

Answer 7

There were two different style cameras that came in the WVOS511 kit, which has since been discontinued. Each of the cameras had different antennas. One is straight on the newer model camera and the one has an elbow type on the older camera. An easy…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

The most likely cause of the "no signal" error you are receiving with the Furrion Vision S Wireless RV Backup Camera System part #FOS43TASF is due to an interruption on the camera's power wire. Make sure that the camera is receiving…

view full answer...

Replacement Antenna for Voyager WAOM562 Backup Camera System

Product Page this Question was Asked From

Continue Researching