4 Inch Long 2" to 1-1/4" Reducer For Bike Rack
Question:
Im looking for a 2 to 1.25 tow hitch sleeve where the 1.25 section is about 4 long. This is to accommodate an old Thule bike rack that uses compression rather than a bolt to hold the rack in position.
asked by: Duane
1
Helpful Expert Reply:
This reducer # HT02 is about 7 inches long but from the center of the hitch pin hole to the end it's about 4 inches long.
expert reply by:
Adam E
1
Product Page this Question was Asked From
Hitch Reducer 2" to 1-1/4" Trailer Hitch Receiver
- Hitch Adapters
- Hitch Reducer
- Bike Racks
- Cargo Carriers
- Hitch Mounted Accessories
- No Extension
- Fits 2 Inch Hitch
- 2 Inch to 1-1/4 Inch
- Brophy
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Seal With Dimensions to Replace 171255UC
- Q&A: Damaged Caused to Travel Trailer Brake Drums and Bearings by High Temperatures
- Article: How Long Can You Boondock in an RV?
- Article: Trailer Wiring Diagrams
- Q&A: How to Measure Hub Face of Mobile Home Hub and Drum
- Q&A: Vent Cover Recommendation for Ventline Roof Part # VD0433
- Q&A: Vent Screen and Screen Base to Replace Part Numbers VD0433 and VD0434 on 2011 Grey Wolf 26RL
- Q&A: Replacement Screen for Ventline Ventadome VD0433 Trailer Roof Vent
- Q&A: Fan Operation for Furrion Chill Replacement RV Air Conditioner
- Article: Gooseneck Trailer Hitch Information and Review
- Article: Trailer Tire Sizing
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Stability Control for Heavy Duty Vehicles
- Article: Trailer Hitch Receiver Sizes