Recommended Wire Clamps To Keep Interior LED Wiring In Boat Trailer Secure
Question:
Is there some type of wire holder that would go on the inside of a boat trailer to hold wires for led lights that would run on the inside of the trailer to light up the underneath section?
asked by: Scott R
Expert Reply:
I recommend the CE Smith Trailer Wiring Clips - Frame Mount - Zinc Plated Steel - Qty 10 # CE16867A which will clip to any supports inside of your boat trailer and keep the wiring for your LED lights nice and clean.
If there is spots you are needing a holder but there is no area for the clip to attach I recommend using some silicone to hold the wires in place.
I included a video of the # CE16867A for you to take a look at.
Product Page this Question was Asked From
CE Smith Trailer Wiring Clips - Frame Mount - Zinc Plated Steel - Qty 10
- Electrical Tools
- Cable Management
- Wire Clips and Clamps
- Silver
- CE Smith
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between Load Range C and D ST175/80D13 Trailer Tires
- Article: Trailer Tire Sizing
- Q&A: How to Install Ground Wire To Trailer Connector on Utility Trailer
- Q&A: How to Determine if Trailer has 84 Spindle to Pick Out Replacement
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Clips and Clamps to Attach Wires and Wiring Harnesses to the Bottom of a Trailer Frame
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Does it Matter if You Have Brakes or Idler Hubs When Measuring Hub Face on Trailer Axle
- Q&A: Recommended Parts for Rebuild/Upgrade of Harbor Freight Trailer
- Q&A: Axle Replacement 1720 Harbor Freight Trailer
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)