Bolt Pattern of Ball Plate Mounting Assembly RP58062
Question:
Do you know the drilling pattern. I have a used trailer that was drilled in a 6 bolt pattern. Want to replace with one that fits the existing.
asked by: Jeffery C
0
Expert Reply:
I attached a picture that shows the distance between the mounting holes of the replacement ball plate assembly part # RP58062 that you referenced.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Ball-Plate Assembly for Reese Friction Sway-Control System
- Accessories and Parts
- Weight Distribution Hitch
- Sway Control Parts
- Ball
- Reese
more information >
Continue Researching
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Q&A: What Is The Correct MORryde X-Factor Crossmember For An AllTrek 4000 Equalizer
- Article: Big Truck Big RV
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Best Towing Mirrors For a 2022 Jeep Gladiator
- Q&A: Backing Up a Trailer when Adding a Bar Style Friction Sway Control
- Q&A: How to Release Tension on Weight Distribution Spring Bar So That Bar Can Be Removed
- Q&A: Replacement Trailer Idler Hub That Uses L68149 Inner and Outer Bearings and 5-on-4-1/2 Bolt Pattern
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Determining Trailer Tongue Weight
- Q&A: Is There A Pin Adapter That Switches A 4 Pin Circuit Board To A 10 Pin Circuit Board
- Q&A: Can I Use the Roadmaster Direct Connect Base Plates with Winch Attached to my 2020 Jeep Wrangler JLU