Does the Bumper Fascia Need to be Trimmed to Install a Curt Hitch on a 2013 Porsche Cayenne
Question:
Your video shows above hitch installation on a VW Tourag. When installing on the Porsche Cayenne does one have to cut an opening in the Cayenne bumper shroud? If so is there a template or detailed instructions on that procedure? Any info specific to the Cayenne would be appreciated.
asked by: Sam T
0
Expert Reply:
I spoke to my contact at Curt and he informed me that you will not need to cut an opening in the rear fascia to install the Curt Trailer Hitch Receiver # C13116 on your 2013 Porsche Cayenne.
I attached installation instructions and video for you to check out also.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 750 lbs TW
- 7500 lbs GTW
- 2 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What Trailer Hitch Receiver Is Going To Fit a 2021 Porsche Cayenne SUV?
- Article: Rooftop Cargo Carriers
- Q&A: Adding a 7-Way Trailer Connector and Brake Controller to a 2012 Ford F-150 with Factory 4-Way
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Installing a 7-Way Trailer Connector and Brake Controller on a 2014 Porsche Cayenne
- Article: Determining Trailer Tongue Weight
- Article: 2005-Current Volkswagen Touareg, Audi, or Porsche Cayenne
- Q&A: Tuson Electronic Sway Control Experiencing Tail Wag At Speeds Over 65 MPH On 2015 Toyota Tundra
- Q&A: Can a 13 Inch Tire and Wheel Replace a 12 Inch Tire and Wheel
- Q&A: Recommended Trailer Hitch for a 2015 VW Golf TDI
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Hitch Receiver Sizes
- Article: Trailer Wiring Diagrams