Which Grease Cap For Hub With 1.940" Bore
Question:
Could you point me in the right direction? Im looking for replacement caps and possibly bearing assemblies. I have an 18’ Quality Steel 7k lb trailer. The axels are marked Lippert 285876. I measured inside the hub at 1.94” but not sure if that is 100 accurate since it was measured on a completed assembly. I have bot opened a hub yet since i was hoping to do with parts on hand. Thank you
asked by: Matt L
Expert Reply:
For the 1.940" bore on your hubs you will need the Fulton Grease Cap - 1.943" Outer Diameter - 1-3/8" Tall - Drive In # F001524, but to determine the correct bearing assemblies you will need to do a little disassembly as I was unable to confirm which bearings you axle uses.
You will need to remove one of your current hubs and look for the bearing numbers stamped in the face of each of the bearings as shown in the included picture of the # L44649.
If your bearings are worn to the point that you cannot read the bearing numbers you will need to use digital calipers like # PTW80157 to precisely measure your spindles according to the included diagram.
If you can provide the bearing numbers or spindle measurements I would be happy to confirm the correct bearings for your trailer.
I included a video of the # F001524 for you to take a look at.
Products Referenced in This Question
Replacement Trailer Hub Bearing - L44649
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.063 Inch I.D.
- Bearing L44649
- Race L44610
- 3500 lbs Axle
- etrailer
more information >
4" Carbon Fiber Digital Caliper
- Hand Tools
- Measuring and Layout Tools
- Digital Calipers
- Carbon Fiber
- Performance Tool
more information >
Product Page this Question was Asked From
Fulton Grease Cap - 1.943" Outer Diameter - 1-3/8" Tall - Drive In
- Trailer Bearings Races Seals Caps
- Caps
- Standard Grease Cap
- 1.943 Inch O.D.
- Fulton
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Measuring a Trailer Tire
- Q&A: Trailer Hub Dust Cap for 1.940 Hub Bore
- Q&A: Grease Cap Recommendation to Replace Cap that Measures 1.90 Inches
- Q&A: Proper Way to Tighten Trailer Spindle of Castle Nut
- Q&A: Grease Cap Recommendation for Hub with 1-15/16 inch Hub Bore
- Q&A: Grease Cap Recommendation for Trailer Hub with 1.938 inch Bore
- Article: Most Popular Wheel Bearings
- Q&A: Grease Caps With Outer Diameter Smaller Than 1.988 Inches
- Q&A: Grease Cap For 1.95 Inch Trailer Hub Bore
- Article: Trailer Maintenance Schedule
- Article: Trailer Lighting Requirements
- Article: Hand Winches
- Article: Testing Trailer Brake Magnets for Proper Function