1-1/2 inch NPT Dump Valve for RV
Question:
In process of converting school bus into skoolie. The grey tank has a 1 1/2” female NPT fitting on one end. What do you have that would allow me to install a dump valve into this fitting. I also need recommendations on drain hose. Thanks,
asked by: Bobby
0
Expert Reply:
For the 1-1/2 inch MPT sewer hose size we have the valve kit part # T1001D which it sounds like you are in need of. At this time we don't have any extension hoses in this size.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Valterra Waste Valve for RV Gray Water Tank w/ Cap - 1-1/2" Diameter - Spigot to Male Thread
- RV Waste Valves
- Straight Valve
- Single Waste Valve - Manual
- 1-1/2 Inch Valve Body
- Stationary Valve
- Valterra
more information >
Continue Researching
- Q&A: Recommended 12V 3.2 Cubic Feet Mini Fridge With Freezer
- Q&A: Differences Between The LaSalle Bristol 34466N11AB And 66N11ABPWT Gate Valves
- Q&A: PEX Connection for Seaflo Diaphragm Pump Variable Flow, # SE96FR
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: Drain Hose to Use With the Valterra 1-1/2" Waste Valve for RV Gray Water Tank With Cap
- Q&A: Correct Spigot Flange for Valterra Bladex Waste Valve Body for RV Gray Water Tank
- Q&A: What Crossbar Pads Will Work With the TracRac Ladder Rack Crossbars
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Hole Spacing Measurements for Valterra RV Sewer Spigot with Flange - 1-1/2" Item # T1006-1
- Article: Trailer Couplers
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Surviving the Night in a Teardrop Camper...During a Winter Storm
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub