How Far Does the handle Stick out on Bulldog Trailer Jack # BD195369
Question:
i working on an engineering project that I am using this jack. I saw on the demo page that the radius of the handle is 6 1/2 inches. I am assuming center to outside of handle. but what I would like to know is what is the distance of the handle form the face of the tube to the outside of the handle in the horizontal direction?
asked by: Doug
Helpful Expert Reply:
I suppose that since you are using this jack but are asking for the measurement that you do not actually have the jack present. So I will be happy to help you. There is a little bit of play in the handle but when measuring from the side of the jack out to the end of the handle it will be at least 4-5/8 inches and at most 4-7/8 inches. I made a picture showing the measurement for you.
Product Page this Question was Asked From
Bulldog Square Jack - Fixed Leg - Sidewind - 15" Lift - 3,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 2001 - 3000 lbs
- Sidewind Jack
- 15 Inch Lift
- Weld-On
- No Wheel or Foot
- Bulldog
more information >
Continue Researching
- Q&A: Bulldog 3K Square Trailer Jack Tube Wall Thickness and Head Dimensions
- Q&A: Replacement Brakes for an AL-KO Axle. Can I Use Heavier Brakes?
- Q&A: How to Measure the Angle of Trailer A Frame To Determine if a 50 Degree A Frame Coupler will Fit
- Q&A: What is Difference Between etrailer # TJD-8000S and # TJD-7000S Trailer Jacks
- Article: Trailer Lighting Requirements
- Q&A: Dimensions of the Inner Tube and Caster Hole for the Bulldog Trailer Jack # BD195369
- Q&A: Which is Better, a Side Wind Trailer Jack or a Top Wind Trailer Jack
- Q&A: Troubleshooting Titan Surge Disc Brake Actuator
- Article: Trailer Jacks