Troubleshooting Trailer Wiring that Only Works on One Side After Install
Question:
I install the connection and one side of the trailer work and the other side dont, I follow all the instructions dint know what can be the problem
asked by: Julio R
1
Helpful Expert Reply:
Typically when this happens the issue is that the connection made on the problem side just wasn't made all the way. If you unplug and replug in the connection on that side that usually cleans up the issue.
You might also make sure that the pins of the trailer connector are clean as well. If you see corrosion take some sandpaper to the pins of the connector.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Aero Bar Roof Rack that Fits 2022 Toyota Highlander
- Q&A: Brake Controller for 2019 Ford Edge With Factory Tow Package
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Recommended Trailer Hitch for a 2018 Toyota RAV4 Hybrid
- Q&A: Recommended Wiring Kit for Towing with a 2017 Toyota RAV4
- Q&A: Connecting Wiring Harness to Battery of 2018 Toyota RAV4 Hybrid
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Q&A: Trailer Tires to Replace 155R12 Tires
- Q&A: Is the Curt Trailer Hitch Receiver Fascia Trim Diagram Correct for 2022 Ford Bronco Sport
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: How to Measure for Trailer Hitch Drop