What is the Bolt Hole to Bolt Hole Width of the Curt 13942
Question:
What is the width from bolt center to bolt center?
asked by: Jody M
1
Helpful Expert Reply:
The Curt # 13942 has the following bolt hole to bolt hole measurements.
The bolt hole closest to engine and middle hole- 34-3/4" apart center on center.
The bolt hole closest to the rear of the truck- 34-1/8" apart center on center.
I've also linked an image with these dimensions.
expert reply by:
Erik B
1
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 8000 lbs WD GTW
- 2 Inch Hitch
- 800 lbs WD TW
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Which Hitch Fits 1994 GMC 3500 with Roll Pan Rear Bumper
- Q&A: Installing a Brake Controller in a 2004 Fleetwood Southwind 32VS with Factory 7-Way
- Article: What is Boondocking
- Q&A: Which Hitch Fits 1993 Chevy Silverado with Roll Pan Bumper
- Q&A: Do the Firestone Coil-Rite Air Helper Springs Fit a 2015 VW Golf Sportwagen TDI?
- Q&A: 2015 Jetta TDI Firestone Air Spring Compatibility
- Q&A: 1990 Chevy Silverado with Roll Pan Bumper Trailer Hitch Recommendation
- Q&A: What is the Diameter of the Replacement Master Cylinder Filler Cap for Titan Model 60 Actuators
- Article: My Trailer Hitch Doesn't Fit
- Article: Trailer Hitch Receiver Sizes
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Trailer Hitch Drop
- Article: Types of Bumpers