What Is the Inside Width of the Bulldog Replacement Pipe Mount for Swivel Jack
Question:
what is the inside width of this part. I need a weld on swivel mount for my 2.5 square tube trailer jack.
asked by: Ed
0
Expert Reply:
The inside width of the u-bracket portion for the Bulldog Replacement Pipe Mount for Swivel Jack part # BD500339 is 2-1/4" which you can see in the photo below. I don't have any that are 2-1/2" so I'd suggest the Bulldog 2-1/4" Long, Weld-On Jack Pipe Mount for 2-1/2" Female Mount and 5/8" Pin part # BD015279.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Bulldog Replacement Pipe Mount for Swivel Jack - Weld On - 5/8" Pull Pin
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Pipe Mounts
- Bulldog
more information >
Continue Researching
- Q&A: Recommended Keeper Pins for RAM 7000 and 5000 Series Jacks
- Q&A: Thickness Of Steel On 2" Diameter Swivel Mounting Point of etrailer Plate # e52JR
- Q&A: Can a Trailer With a 50MM Coupler Be Safely Towed With a 1-7/8" Hitch Ball?
- Q&A: Outer Diameter of Pipe for etrailer Round, Pipe Mount Swivel Jack w/ Footplate
- Q&A: How Should the Safety Chain Attachment Loop part # E950 Attach to Trailer Hitch
- Q&A: Fuse Location to Power an Electric Trailer Brake Controller on a 2005 Chevy Silverado
- Q&A: Will Bulldog Replacement Pipe Mount for Swivel Jack Work with My Trailer Jack
- Article: Determining Trailer Tongue Weight
- Article: Where to Position the Trailer Axle?
- Article: How to Wire an Electric Winch
- Article: How Does a Trailer Hitch Coupler Work?
- Article: Wiring a Tow Vehicle to Tow a Dinghy
- Article: Trailer Jacks
- Article: Trailer Tire Sizing