Lippert Power Tongue Jack Light Switch Replacement
Question:
I have a brand new Lippert Power Tongue Jack on a brand new Keystone Travel Trailer that I just purchased. The light switch will not stay in the on position. When I press it, it pops back out to the off position. If I hold it in the on position the light stays on. Just wont stay in the on position.
asked by: Tris T
0
Expert Reply:
Sounds like the switch is broken. Since it's a brand new travel trailer the dealer should take care of the problem for you but we do have the part # LC226018 which would be the correct light switch for the Lippert trailer jack # LC285318.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Lippert Electric Trailer Jack with Footplate - A-Frame - 18" Lift - 3,500 lbs - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- Bolt-On
- 1 Jack
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Weight Distribution Recommendation for a 2024 Jayco Flight 284BHS
- Q&A: Replacement 3500-lb Electric Tongue Jack for Lippert 1817941
- Q&A: What Kayak Carriers Will Fit The Thule TracRac TracONE Crossbars
- Q&A: Lowest-Profile A-Frame Trailer Jack For Tailgate Clearance
- Q&A: Hitch Extender For 2-1/2 Inch Hitch For Weight Distribution
- Article: RV Pre-Departure Checklist
- Q&A: Replacement Toggle Switch For Lippert Power Stance Trailer Jack
- Article: Trailer Wiring Diagrams
- Q&A: Correct Replacement for an Atwood Water Heater GC6AA-9E
- Article: Trailer Jacks
- Article: How (and Where) to Connect an RV Propane Grill
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How to Raise Your Travel Trailer Height
- Article: Most Popular Wheel Bearings