Reinstalling Rear Panel On Extang Solid Fold 2.0 For Toyota Tundra
Question:
The rear panel of my extang solid fold 2.0 came off. I dont think anything broke. It looks like it just snaps back on. It is 2 years old. I have taken the cover off the Toyota Tundra and tried to reattach the back panel to the middle one, but cant seem to snap it back into place. Any advice would be appreciated.
asked by: Jesse
Expert Reply:
To reinstall the rear panel on your Extang Solid Fold 2.0 you will first want to make sure is laying on a flat, supported surface. You will need to use a T-20 Torx Head bit to remove the screws holding the end cap to your cover.
Next slide the panel onto the hinge from the side that you removed the end cap from. You will want to hold the panel at a 45 degree angle. With the panel reinstalled you will need reinstall the end cap.
If you struggle to slide the panel back on, take a close look at the channel on the panel to make sure it is not damaged and causing issues with the reinstallation.
If you need the replacement rear panel you can use # EX83475-62 as long as your Tundra is a 2014-2020 with the 5 1/2" bed using the Extang Solid Fold 2.0 Hard Tonneau Cover.
Product Page this Question was Asked From
Replacement Tail Panel Assembly for Extang Solid Fold 2.0 Hard Tonneau Cover
- Accessories and Parts
- Tonneau Cover
- Panels
- Extang Solid Fold 2.0
- Extang
more information >
Continue Researching
- Q&A: How To Tell If Parts Are Missing From Rear Panel Extang Solid Fold Tonneau Cover That Blew Off Truck
- Article: Flat Towing Package for 2011-2014 Ford F-150