5th Wheel Landing Gear Works Opposite of Switch
Question:
I recently installed an LG-3 landing legs kit on my fifth wheel and the switch to raise and lower is reverse. To change the polarity I should swap the two lines going to the motor - correct ?
asked by: Michael
1
Helpful Expert Reply:
If you reverse the leads from the switch as you described, the motor on your landing gear will work correctly.
expert reply by:
Mike L
1
Product Page this Question was Asked From
Stromberg Carlson Electric Landing Gear Set - Weld On - 34-7/8" Lift - 6,500 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 6001 - 7000 lbs
- Electric Jack
- Landing Gear
- 35 Inch Lift
- Weld-On
- 2 Jacks
- Stromberg Carlson
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Are Landing Gear Legs for a 5th Wheel Trailer Brand Specific
- Q&A: Recommended Replacement For An Atwood Landing Gear On A 2005 Fleetwood Prowler
- Q&A: How to Determine Correct Replacement Lead Leg for Landing Gear
- Article: Best Landing Gear
- Q&A: Replacement Landing Gear for 2010 Open Range 5th-Wheel Trailer
- Q&A: How To Determine the Correct Replacement Landing Gear For A 2010 Dutchman Denali 260RKX 5th Wheel
- Q&A: Inverter/Converter Recommendation for Replacing MagneTek Series 6400A in Pop Up
- Q&A: Replacement Landing Gear Motor For a 2021 Keystone Springdale 5TH Wheel Camper
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Choose a Bike Rack for a Motor Home or RV
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure a Trailer Axle
- Article: My Trailer Hitch Doesn't Fit
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box