Wire Loom to Use With Bulldog Powered-Drive Kit for Single-Speed Jacks w/ 12,000-lb Capacity
Question:
What size cable clamps do I need to order to secure the wiring loop to the side of the trailer? Id like to order everything at one time so I can get the install done quickly.
asked by: Richard
0
Expert Reply:
To secure the wire loom of the Bulldog Powered-Drive Kit for Single-Speed Jacks w/ 12,000-lb Capacity # BD1824200100 you would want to use the cable clamp part # SWC8925-1 which has an inner diameter of 7/8 inch.
expert reply by:
Jameson C
0
Products Referenced in This Question
Cable Clamp - White Natural Nylon - 7/8" Diameter Closed ID - Qty 1
- Wiring
- Tools for Wiring
- Wire Clips
- Spectro
more information >
Product Page this Question was Asked From
Bulldog Powered-Drive Kit for Single-Speed Jacks w/ 12,000-lb Capacity
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Powered-Drive Kit
- Bulldog
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Installation Instructions for Bulldog Powered-Drive Kit # BD1824200100
- Q&A: How Much Slack Is Needed In Trailer Wire Connection To The Tow Vehicle?
- Q&A: Replacement Trailer Grease Seals for Allis 5013 29772
- Q&A: Replacement Trailer Hub/Drum for Part Number 2420801
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Kit to Convert 2021 Vanleigh Pinecrest 335RLP to Electric Over Hydraulic Disc Brakes
- Q&A: How To Charge 12v Batteries Wired in Parallel
- Q&A: Using NOCO 2 Bank Charger With Parallel Batteries in Truck
- Article: Trailer Wiring Diagrams
- Article: Trailer Hitch Receiver Sizes
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Stability Control for Heavy Duty Vehicles
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Article: Testing Trailer Brake Magnets for Proper Function