Slide Topper for Slide Outs that Measure 91 and 151 inches

Question

Question:

need correct slider awningswhite Flange to Flange 91 and 151

asked by: Ken D

1

Helpful Expert Reply:

For the 91 inch slide out the correct size slide topper is the part # LCV000163299 and then for the 151 inch slide out you'd want the part # LCV000165061.

expert reply by: Jameson C

1

Answer 1

For slide out awnings you pick them out based on width including the flange that goes around the outside of the slide out. The part #LCV000163288 would be the correct fit if you have a box widht of 86" to 91-3/4" and the part…

view full answer...

Answer 2

The 84 inch slide-out will use a 90 inch awning slider length, 90 inches will use a 96 inch length, and 156 will use the 162 inch length. So for the 84 inch slide-out you can use #LCV000165062 for black or #LCV000163287 for white. For the 90 inch…

view full answer...

Answer 3

Measuring to pick out the correct slide topper for an RV like your 2018 Forest River Rockwood is pretty easy. You have to measure the box width including the flange on it and you'll be set. So the Solera part #LCV000163288 that you referenced is…

view full answer...

Answer 4

The correct slide topper for your trailer with a 153-1/2 inch measurement is the 13 foot option, which comes in either black or white: - Black: Solera RV Slide-Out Awning #LCV000168109 - White: Solera RV Slide-Out Awning #LCV000163300 And because you…

view full answer...

Answer 5

When choosing the slider you want to measure the outside front of box width including the flange. Then you need to select a slider that extends a minimum of 2-1/2 inches beyond each side of the box width. For example, the Black Solera Slider…

view full answer...

Answer 6

Your 13-10 equalizers, which should be equivalent to Equalizer #TREQ310 measures 6-1/16 inches from bolt hole to bolt hole (see accompanying photo) and due to that you will need to use the E-Z Flex Heavy Duty Rubber Suspension System #K71-652-00.…

view full answer...

Answer 7

I've actually answered a similar question on this before and found: In my research I found that the grease seal you are looking for could have an inner diameter of either 2.24 or 2.12 inches and an outer diameter of 3.37 inches when measured with…

view full answer...

Answer 8

The correct replacement for the Oil Seal 225255UC is the Oil Seal part #9103309. These both have a 2.24/2.25" inner diameter and 3.37" outer diameter. They are also designed for use with oil bath hubs.

view full answer...

Answer 9

M12-1.5 and 1/2"-20 threads are not going to be interchangeable. The diameter of an M12 thread is only going to be 0.4724" while 1/2" threads are going to be 0.500" in diameter. We currently only have 1/2"-20 Lug Nuts…

view full answer...

Answer 10

If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…

view full answer...

Answer 11

I recommend the Solera RV Slide-Out Awning - 13'1" Wide - 48" Projection #LCV000168109 which will fit RV's with slide outs that are 152" to 157" wide and up to 48" long, the awning rail is included. This is also…

view full answer...

Answer 12

If your rear indicators are not working, it's almost certainly a poor ground, so the first thing to do is take a look at your ground connections to make sure they are attached to bare metal surfaces and free of any paint, dirt or corrosion. What…

view full answer...

Slide Topper for Slide Outs that Measure 91 and 151 inches

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching