Will the Bearing Buddy Bearing Protectors Work With EZ-Lube Axles
Question:
I have ez lube spindles on my trailer. If I install bearing protectors do I need to remove the zerk fitting from the spindle? Thanks.
asked by: Rick
0
Expert Reply:
The grease zerks on the spindle will need to be removed before the Bearing Buddy Bearing Protectors like part # BB1980A could be installed. I have attached a full list of options below.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Bearing Buddy Bearing Protectors - Model 1980A w/ Auto Check - Chrome Plated (Pair)
- Trailer Bearings Races Seals Caps
- Caps
- Bearing Protector Grease Cap
- 1.98 Inch
- Bearing Buddy
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Should Bearing Buddies Buddies be Used on EZ Lube Trailer Axles
- Q&A: Will Bearing Buddy Fit on EZ Lube Spindle
- Q&A: Do Bearing Buddies Work Well on Travel Trailer Hubs
- Q&A: Should I Have Constant 12 Volt Power On Brake Output Pin On 7-Way Connector
- Q&A: How To Tell If Bearing Buddy Has Enough Grease
- Q&A: When Using Bearing Buddy Bearing Protectors Do I Need To Repack Bearings Periodically?
- Q&A: 05680-C Master Cylinder Replacement for Trailer Recommendation
- Article: Most Popular Wheel Bearings
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Article: How to Charge a Dump Trailer Battery
- Article: Trailer Tire Sizing
- Article: Replacement Automotive Lighting
- Article: Trailer Tester Battery Replacement for Part Number 8010