Powered A-Frame Jack to Replace Side Wind 5k Trailer Jack
Question:
What is the electric powered version of the etrailer Round, A-Frame Jack - Sidewind - 15 Lift - 5,000 lbs? Also do you have higher capacity? I will use it to replace an a-frame mounted manual side wind jack.. The desired is to crank enough height to get the proper ramp angle for a car trailer, as I do with the manual jack now.
asked by: Stan
Expert Reply:
Bulldog has a powered a-frame jack with the part # BD500199 that would work great as a replacement for the etrailer.com A-frame jack # TJA-5000S-B. It has a similar weight capacity and also has a drop leg feature that will allow for quicker raising and lowering.
Products Referenced in This Question
Bulldog Powered Drive Trailer Jack - Drop Leg - A-Frame - 22" Lift - 4,000 lbs - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 22 Inch Lift
- Bolt-On
- 1 Jack
- Bulldog
more information >
Product Page this Question was Asked From
Round A-Frame Trailer Jack - Sidewind - 15-5/8" Travel - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Sidewind Jack
- 16 Inch Lift
- Bolt-On
- Weld-On
- No Wheel or Foot
- etrailer
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: 2 inch Outer Diameter A-Frame Trailer Jack Recommendation
- Q&A: Alternative Ways to Power the Ultra-Fab Electric A-Frame Jack
- Q&A: Smaller Trailer Tire Than 215/75R14 w/ 5 on 4-1/2" Bolt Pattern To FIt in Garage
- Article: Trailer Maintenance Schedule
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Mounting Tab and Hole Size and Spacing of Ultra-Fab # UF48-979006 Scissor Jack
- Q&A: How to Find Connector for Back Up Sensors When Installing 118760 Trailer Wiring on 2019 Honda Pilot
- Q&A: Wiring 3-Wire Breakaway Switch as Replacement for 2-Wire Switch
- Q&A: Correct Grease Seal for a Boat Trailer that 10-19 Seal won't Fit