Which Fixed Drop Ball Mount for 2 inch ball
Question:
Hi, is like to use this system but, with the hitch in the lowest setting the upside down ball has very little clearance. Could you recommend a hitch with a 2inch ball that is a similar length to the system included with this hitch? Ty
asked by: C R
Expert Reply:
I have a solution but we do not offer an adjustable ball mount like the Gen-Y Adjustable 2-Ball Mount w/ Stacked Receivers # 325-GH-414 with a single 2 inch ball.
I recommend a fixed ball mount like the B&W Heavy-Duty Ball Mount - 3" Rise, 4" Drop # BWBMHD30013 which is 11 3/8 inches long, and will offer the ground clearance you are looking for. You will need a 2 inch ball like # A-90, and a hitch pin and clip like # PC3. I included the video review and a helpful article that shows you how to determine the correct rise or drop for setup.
Products Referenced in This Question
2" Hitch Ball - 1-1/4" Diameter x 2-5/8" Long Shank - Chrome - 10,000
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 2 Inch Diameter Ball
- 2-5/8 Inch Shank Length
- 1-1/4 Inch Diameter Shank
- 10000 lbs GTW
- Class IV
- Class V
- CURT
more information >
B&W Heavy-Duty Ball Mount - 3" Rise, 4" Drop - 11-3/8" Long - 16,000 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- 1-1/4 Inch Ball Hole Diameter
- Steel Shank - Gloss Black
- Drop - 4 Inch
- Rise - 3 Inch
- Fits 2 Inch Hitch
- 16000 lbs GTW
- Class IV
- B and W
more information >
Pin and Clip for 2" and 2-1/2" Hitches - 5/8" Diameter x 3-1/4" Span
- Hitch Pins and Clips
- Standard Hitch Pin
- Fits 2 Inch Hitch
- Fits 2-1/2 Inch Hitch
- 5/8 Inch Diameter
- 4 Inch Span
- Draw-Tite
more information >
Product Page this Question was Asked From
Gen-Y Adjustable 2-Ball Mount w/ Stacked Receivers - 2" Hitch - 5" Drop/Rise - 10K
- Trailer Hitch Ball Mount
- Adjustable Ball Mount
- 2 Inch Ball
- 2-5/16 Inch Ball
- Two Balls
- Steel Ball
- Steel Shank - Gray
- Drop - 5 Inch
- Rise - 2 Inch
- Fits 2 Inch Hitch
- 10000 lbs GTW
- Class IV
- Stacked Receivers
- Gen-Y Hitch
more information >
Continue Researching
- Q&A: Recommended Cushioned Equalizer Replacement Options For Factory Equalizer 6" Wide and 4" Tall
- Q&A: Can Gen-Y Adjustable 2-Ball Mount Be Used with Any 2" Receiver to Tow Trailer and Mount Accessory
- Q&A: Compatibility of Stacked Receiver Ball Mounts with Weight Distribution Systems
- Q&A: Replacing 6-Way on Trailer With 7-Way Connector
- Q&A: Recommended Ramps To Load Can Am Spyder On Trailer
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: Pintle-Hitches
- Q&A: Dual Hitch Ball Mount For Towing a Small Boat Trailer And Carrying a Cargo Carrier
- Q&A: Which Dual Hitch Adapter Has the Highest Tongue Weight Capacity
- Article: How to Measure for Trailer Hitch Drop
- Article: How Level Should a Tow Bar Be When Flat Towing
- Article: Tow Dolly vs Flat Towing vs Trailer Towing
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Cargo Tie-Down Methods