What are the Dimensions of the Roadmaster 8 inch High - Low Hitch Adapter for Towing My 2004 Jeep
Question:
what is the length between the adpaterpin hole to 45 degree brace? My bumper extends about 4.5 inches beyond the face of the hitch receiver on the RV
asked by: Jim W
0
Expert Reply:
The length from the center of the hitch pin hole to the angled brace is 4-1/2 inches. The measurement from the center of the hitch pin hole to the center of the receiver pin hole is 10-3/4 inches.
expert reply by:
Robert G
0
![Bob G](https://images.etrailer.com/static/images/catg/people/287_tn.jpg)
Product Page this Question was Asked From
Roadmaster High-Low Adapter for Tow Bars - 2" Hitches - 8" Rise/Drop - 10K GTW, 400 lbs TW
- Accessories and Parts
- Tow Bar
- Hitch Adapters
- High-Low Adapter
- Fits 2 Inch Hitch
- 8 Inch Rise/Drop
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Flat Towing Parts for a 2024 GMC Canyon Denali
- Article: How to Choose a High-Low Adapter
- Article: How to Measure for Trailer Hitch Drop
- Article: Top Gifts for Dads in 2024
- Article: Roadmaster Vehicle Specific Base Plates
- Article: Must-Have Flat Towing Components
- Article: Flat Towing Package for 2016-2018 Ford Focus
- Q&A: Can I Upgrade My Dometic Fan-Tastic Vent With The Fan-Tastic Vent 7350 Series Upgrade
- Q&A: After Installing The Fan-Tastic Fan Upgrade Kit The Remote Wont Program
- Q&A: How does the Demco Stay-In-Play's break-away switch attach to the vehicle?
- Q&A: How to Install the Monitor Light from the SMI Stay-IN-Play on a 2016 Cadillac SRX
- Article: How Level Should a Tow Bar Be When Flat Towing
- Q&A: Is There Play in Lower Hitch Opening of Blue Ox Adjustable High Low Adapter # BLU48CR
- Q&A: How to Flat Tow 2019 Ram 1500 Limited 4x4 Behind Motorhome
Bob L.
6/27/2020
I have a 2018 Tiffin Red 37BA motor home. I tow a 2013 Ford Edge. The distance from the Ford Edge towing pin holes is 25". The distance to the Red receiving hitch hole is 17". It looks to me like I need an 8" lift. the information I have reviewed on your website looks like the Roadmaster RM-048-8 would be the adapter I would need. However, the bumper on my Red extends 7.5" at the top of the adapter and the adapter only gives me 7.25" when I need at least 8". The angled brace is not a problem. Do I have the measurements right? If so, do you have a solution to my problem?