Orientation For Bolt On Channel Support on Brophy # SPTC Stake Pocket Spare Tire Mount
Question:
The instructions are poor. Which way does the bottom bracket go, channel facing up or down?
asked by: J G
0
Expert Reply:
The mounting plate/channel for the Brophy # SPTC Stake Pocket Spare Mount is installed with the flat part facing up and the channel part facing down. I have attached a demonstration video showing the orientation.
expert reply by:
Les D
0
Product Page this Question was Asked From
Brophy Trailer Stake Pocket Spare Tire Mount - Black Powder Coat
- Spare Tire Carrier
- Stake Pocket Mount
- 5-Bolt
- 6-Bolt
- 8-Bolt
- Trailer
- Brophy
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How to Tell if 10K Dexter Nev-R-Adjust Electric Trailer Brakes Are for Driver or Passenger Side
- Article: Trailer Tire Sizing
- Q&A: Best 2 Inch Hitch for a 2023 Kia Sportage
- Q&A: How To Wire In The V-Shaped Identification Light Bar When Replacing Light With Only 1 Wire
- Q&A: Replacement 7 Spoke Aluminum Trailer Wheel for Aluma Trailer
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: What Is The Weight Of The Kenda Karrier ST235/85R16 Trailer Tire On 16" Black Mod Wheel AM32743B
- Article: Printable Trailer Bolt Hole Pattern Template
- Q&A: Edge CS2 Evolution Diesel Tuner - How Do I Unpair With An Old Vehicle?
- Article: Trailer Wiring Diagrams
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Hard Tonneau Covers vs Soft Tonneau Covers
- Article: How to Raise Your Travel Trailer Height