How Does 6-way Harness part # PK11609 Come Apart to Attach Wires
Question:
run light wire came off how do i get the plug apart to reconnect?
asked by: Fred
0
Expert Reply:
If you fastforward to the 1 minute mark of the install video I attached for the 6-way harness part # PK11609 that you referenced you'll see that there's a screw that holds the back of the connector to the main housing that you'll need to remove and once it's off you can push out the inner section and attach the wiring to it.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Pollak 6-Pole, Round Pin, Trailer Wiring Socket - Vehicle End
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug Only
- 6 Round
- Pollak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Comparing etrailer and Blue Ox Baseplate Kits For A 2023 Jeep Gladiator
- Article: Trailer Wiring Diagrams
- Q&A: Troubleshooting Brake Lights Overriding Tow Bar Lighting Turn Signals
- Q&A: Can Curt Tow Bar Lighting Kit for 2023 Jeep Gladiator Install with Trailer Wiring
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Q&A: Availability of InvisiBrake Installation Video on 1998 Jeep Wrangler
- Q&A: Does Hopkins Tow Bar Lighting Kit of 2017 Jeep Wrangler Control Brake Lights
- Q&A: Tow Bar Lighting Solution for 2023 Jeep Wrangler that Allows Charge for Battery
- Q&A: Choosing Between the Brake Buddy Select 3 and the Blue Ox Patriot Supplemental Braking System
- Article: Brake Controller Installation: Starting from Scratch
- Article: Tow Bar Wiring Overview
- Article: Diode Installation Instructions for a Dinghy with Separate Tail Light Wiring
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Tow Bar Wiring: Which Wiring Kit is for You?