Should the Replacement Bottom Channel Cover for Thule AeroBlade Bars Be Glued
Question:
Does this need to be glued in?
asked by: Byron D
0
Expert Reply:
The Replacement Bottom Channel Cover for Thule AeroBlade Load Bars # 852-4498-001 does not need to be glued into place; it should fit snugly because of the barbed sides on the strip that will keep it in the channel. I've linked a photo from our product page that shows this. If you wanted to provide it with some extra security, you could use some small amounts of super glue.
expert reply by:
Erik B
0
click to enlarge
Product Page this Question was Asked From
Replacement Bottom Channel Cover for Thule AeroBlade Load Bars - 14-1/4" Long - Qty 1
- Accessories and Parts
- Roof Rack
- Crossbars
- Channel Covers
- Thule
more information >
Continue Researching
- Q&A: What are the Measurements for the Replacement Vortex Strip for Rhino-Rack Vortex Aero Crossbars
- Q&A: Replacement Slide Scale and Channel Covers for Thule AeroBlade Load Bars
- Q&A: Comparing Thule AeroBlade Crossbars vs WingBar Evo Crossbars
- Q&A: How Does Rubber Strip on Top of Thule Aeroblade Crossbars Install
- Q&A: Replacement Rubber Strips for Roof Rack Crossbars with Channels
- Q&A: What is the Width of the T-Slot on the Thule ProBars for the Replacement Upper Rubber Cover Strip
- Q&A: Troubleshooting Rhino Rack That Whistles
- Article: How to Tie Down Luggage on a Roof Rack
- Article: How to Measure for Trailer Hitch Drop
- Article: Rooftop Cargo Carriers
- Article: Roof Rack Information
- Article: Calculating Portable Generator Power Needs
- Article: Hyk Outdoors Teardrop Campers: Happy Camping Without the Hassle
- Article: Best Bike Racks for Electric Bikes