Trailer Running Lights not Working on a 2014 Ford F-150 After Being Pinched
Question:
My trailer lights got pinched in my hitch and snapped half of them...I wired back together and replaced 2 blown fuses #67 and 73 and my 2014 f-150 still isnt sending power to trailer for running lights tested with voltmeter and trailer isnt turning running lights on wired straight to batterie.
asked by: Branden C
Expert Reply:
There are a few possibilities that could be causing the problem with the running lights for your 2014 Ford F-150's trailer.
First, when you reconnected the wires, there may still be some of the wiring exposed. If that wiring is touching the metal frame, it could be grounding out the running lights. That would prevent them from functioning. Make sure none of the wiring is touching the frame of your trailer (except for where the ground wire is supposed to, of course).
Second, when the circuits blew, they may have sent shorts up through your 4 or 7-way. Use a circuit tester like part # PTW2993 to test the harness on your vehicle to make sure everything is functioning properly. That will also help you determine if the problem is on the vehicle side or the trailer side. If things aren't working properly on the vehicle side, something might have blown in the harness itself, and it may need to be replaced.
Third, some of the circuits may have gone bad when they were pinched. If the above solutions don't solve your problem, check each wire to make sure they aren't fried somewhere. If you find any signs of this, replace that wire. You can use part # 10-1-1 for that.
If those solutions don't solve your problem, let me know and I will assist you further.
Products Referenced in This Question
Product Page this Question was Asked From
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Recommended Tow Wiring for a 2023 Kia Telluride With LED Lights
- Q&A: Troubleshooting Trailer Brake Message on 2019 Ford F-150 with OEM-Style Brake Controller Installed
- Q&A: Adding a Battery on an Enclosed Trailer to Power Interior Lights
- Q&A: What Gauge Wire Does The Curt USCAR Connector C56229 Use?
- Q&A: Can Electric Brakes be Used on a Boat Trailer
- Article: Brake Controller Installation for 2007 (New Body Style) - 2013 GMC Sierra and Chevy Silverado
- Article: Testing Trailer Brake Magnets for Proper Function
- Q&A: What Gauge Wire Is Needed To Run Charge Line for Battery From Truck to Trailer
- Q&A: How to Charge a Trailer Battery Through a 7-Way Connector