Who Manufacturers Furrion Stove Grate Item # CFSRE21SA002

Question

Question:

Who is the manufacturer of this stove grate?

asked by: Hugh D

0

Expert Reply:

The company Furrion is who manufacturers the Die-Cast Grate part # CFSRE21SA002 that you referenced.

expert reply by: Jameson C

0

Answer 1

If you have a Furrion range that has three total burners with one in front and two in back the #CFSRE21SA002 that you referenced would be the correct fit for it.

view full answer...

Answer 2

The Die-Cast Grate for Furrion Range Cooktop #CFSRE21SA002 that you referenced weighs 8 lbs. You also are in need of the Replacement Trivet Support Bumper for Furrion Chef Collection Gas Cooktop #CFGH4ZSASSTRIVETSPRT.

view full answer...

Answer 3

We don't carry Dometic ranges and ovens, so I can't confirm this, but I do believe the CU-434 you've referenced is actually the range/oven combo that uses the same cooktop/range piece as part CU-423. Because of this, based off…

view full answer...

Answer 4

The Die-Cast Grate for Furrion Range Cooktop - 2 Piece #CFSRE21SA002 comes in two parts and each has four feet that will sit in its own gasket. Making 8 feet total. You will need 8 Furrion Grill Grate Gasket for Furrion Ranges and Furrion 2-in-1…

view full answer...

Answer 5

The Die-Cast Grate for Furrion Range Cooktop or 2-in-1 Range Oven #CFSRE21SA002 will absolutely allow you to close the glass top on your Furrion 2-in-1 Range Oven as this is simply an upgrade and will have the same footprint as your current grate.…

view full answer...

Answer 6

Since we have confirmed with Furrion that the replacement top part #C-FSRE21SA-SS-003 fits your FGHWCLDA-SS that means that you could use the grate part #CFSRE21SA002 as well to upgrade what you have.

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

We don't know for sure if the #CFSRE21SA002 will fit on your Amana RV stove since they're not designed for the same product, but I can tell you that the grates are 19" long (wide) and will sit 1-3/8" tall. The front grate is…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Who Manufacturers Furrion Stove Grate Item # CFSRE21SA002

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching