Troubleshooting Trailer Brake Controller Output on 2011 Ram 2500
Question:
On my 2011 ram 2500 my brake controller only engages when I use it manually and not when I press the
asked by: Dan K
0
Expert Reply:
The fact that your trailer brakes only engage when you use the manual override sounds like you have an issue with the brake light power on the red wire going into your brake controller. I recommend using the circuit tester # PTW2993 to check the red wire making sure you have braking signal getting to the controller when you press the pedal.
expert reply by:
Jason S
0
Products Referenced in This Question
Product Page this Question was Asked From
Hopkins Endurance 5th Wheel/Gooseneck 90-Degree Wiring Harness with 7-Pole Plug
- Custom Fit Vehicle Wiring
- Fifth Wheel and Gooseneck Wiring
- 10 Feet Long
- Custom Fit
- 7 Round - Blade
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: 7-Way Trailer Plug Adapter or Compatibility with Lance Slide-In Truck Bed Camper
- Q&A: What Is An OEM Prep Package And How Do I Know If I Have It
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Lance Camper Wiring Harness Recommendation
- Q&A: Does Curt 7-Way Fit 2023 Ford F-350 Cab & Chassis
- Article: Tire TLC: How & When to Check Your RV/Trailer Tire Pressure
- Article: Ram Trailer Tow Prep Package
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Trailer Wiring Diagrams
- Q&A: Does Truck with 6-1/2 ft bed Have to Use Slider Hitch for Turning Clearance with Fifth Wheel Hitch
- Q&A: Recommended In Bed 7-Way for a 2024 Ford F-250
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: How To Plug 1997 Lance Truck Camper Into 7-way Connector On 2016 Ford F-250