Troubleshooting Constant Power on Right Brake Light Vehicle Side
Question:
Hi I recently installed the Hopkins 4 flat wiring and when testing with my trailer the right rear brake light comes on as soon as the trailer was plugged into the car. After investigating for a good ground and pinched wires. I found that there is 10v indicated on the green wire pin on the car side constantly. Do I need a new controller? Or is there another issue? Best,
asked by: Nathan
Expert Reply:
If the green output wire of the wiring harness # HM11143764 is having constant power, that is an issue. I recommend checking the green input wire prior to the module because the green wire should only have power when the brakes are applied or when the right turn signal is on. If there is constant power before the module, then I recommend checking the connection for bent pins or corrosion. If the input wire is working correctly and the output wire is not, then you know the module is bad and needs replaced.
Product Page this Question was Asked From
Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: How to Replace a 4-Way Trailer Connector with 8 Wires
- Q&A: Replacement Brake Shoes for Dexter 12k Axles
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Do Smaller Trailers with Single Axles Come with Brakes Installed
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Availability of 2 Inch Receiver Hitch for 2014 Volkswagen Jetta TDI
- Q&A: Trailer Hitch Fit and Towing Capacity for a 2014 Volkswagen Jetta SportWagen
- Q&A: Trailer Hitch Receiver Fit For 2013 Volkswagen Passat w/ 2.0L Diesel Engine
- Article: Trailer Wiring Diagrams
- Article: My Trailer Hitch Doesn't Fit
- Article: Rooftop Cargo Carriers