Are Their Holes on Brackets of End Brackets Curt Hitch # C13068
Question:
Good morning, I noticed on this hitch that there are holes on each end of the hitch you can see them in the 360 degree photos. Are these drain holes or are they for some other purpose? Thank you!
asked by: David
0
Expert Reply:
The holes you can see in some of the pictures of the Curt hitch part # C13068 don't actually go all the way through and allow access to the hitch's cross tube. Otherwise that would allow water to get into the hitch and potentially cause rust prematurely.
expert reply by:
Jameson C
0
![Jameson C](https://images.etrailer.com/static/images/catg/people/371_tn.jpg)
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 5000 lbs WD GTW
- 2 Inch Hitch
- 500 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Recommended Hitch with Best Ground Clearance for 2013 Honda Odyssey
- Q&A: Does Tongue Weight Capacity Get Reduced if Carrying Bike Rack
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: Is 2014 Honda Odyssey Rated for Use with Weight Distribution
- Q&A: Is Bumper Beam Modification Needed to Install Draw Tite Hitch part # 76025
- Q&A: Recommended Hitch for a 2024 Honda Pilot
- Q&A: Comparing The etrailer And Curt Trailer Hitches For A 2023 Toyota Sienna
- Article: Best Bike Racks for Women's Bikes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams