Solution for Husky Centerline Weight Distribution System that Needs More Drop
Question:
I have switched my tow vehicle from 2013 pilot to ram 1500 2020. Do I need to buy a new sway control system. I think the trailer won’t be level because the heights are different?
asked by: Richard M
0
Expert Reply:
If you are the bottom of the adjustment holes of your Husky Centerline Weight Distribution system and you need more drop so that your trailer can sit level all you need is a shank with more drop like the Curt # C17123 which will work great with your Husky system. This is capable of up to 8-1/4 inches of drop.
expert reply by:
Jameson C
0
Products Referenced in This Question
Curt Welded Weight Distribution Shank 7" - 10 Hole Adjustment
- Accessories and Parts
- Weight Distribution Hitch
- Shanks
- 1500 lbs TW
- 15000 lbs GTW
- Fits 2 Inch Hitch
- Round - 8 Inch Drop
- Trunnion - 8 Inch Drop
- Round - 12 Inch Rise
- Trunnion - 11 Inch Rise
- CURT
more information >
Product Page this Question was Asked From
Curt Welded Weight Distribution Shank 7" - 10 Hole Adjustment
- Accessories and Parts
- Weight Distribution Hitch
- Shanks
- 1500 lbs TW
- 15000 lbs GTW
- Fits 2 Inch Hitch
- Round - 8 Inch Drop
- Trunnion - 8 Inch Drop
- Round - 12 Inch Rise
- Trunnion - 11 Inch Rise
- CURT
more information >
Continue Researching
- Article: How to Measure for Trailer Hitch Drop
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Can Trailer Weight Capacity Be Increased by Changing One Trailer Axle
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Q&A: Replacement Drop Shank for the Curt TruTrack Weight Distribution System Part # C17500
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Calculating Portable Generator Power Needs
- Q&A: How To Measure To Make Sure The MORryde CRE3000 Equalizers Will Fit Your Trailer
- Q&A: Equal-I-zer Weight Distribution Shank that has More than 3 Inches of Drop
- Q&A: Extending Curt Weight Distribution Hitch to Clear Electric Tongue Jack
- Q&A: Replacement Bearings for Dexter 8-222 Hub
- Q&A: Should Hitch Ball Angle Be Adjusted Up and Down or Angled to the Rear Using Weight Distribution