Comparing the Level Sensor on the Curt Echo and Tekonsha Prodigy RF

Question

Question:

I read your article on the Curt vs. Prodigy RF controller. I was hoping it would identify the advantage of having the level sensor? What is the advantage of the level sensor in the prodigy v.s the Curt to another wired controller for that mater?

asked by: Derek G

0

Expert Reply:

In regards to the Curt Echo Wireless Trailer Brake Controller part # C51180 and Tekonsha Prodigy RF Wireless Trailer Brake Controller, the Curt Echo can be mounted in any direction whereas the Tekonsha RF has to be mounted parallel to the direction of travel. This is one of a few reasons I recommend the Curt Echo over the Tekonsha RF.

expert reply by: Conner L

0

Answer 1

The best option for wireless brake controllers is the Curt Echo #C51180. It is the easiest to plug in and go when you need to use a brake controller with your trailer. Once you have a 7-way connector installed in your vehicle, all you need is to…

view full answer...

Answer 2

Performance-wise the Prodigy RF part #90250 and the Curt Echo part #C51180 are right on par with each other. They are both proportional controllers which means they will sense the amount of braking applied and apply the trailer brakes in an equal…

view full answer...

Answer 3

I checked with Redarc and a few other brake controller manufacturers and they state that your 2024 Mercedes Sprinter 3500XD does not have an OEM brake controller install port under the dash like previous models so you would have to hardwire in the…

view full answer...

Answer 4

Some newer cars, vans and small trucks, especially those with large, aftermarket tires, may require the use of Class S chains. Class S tire chains are designed for use on vehicles with restricted wheel well clearance. I have attached a photo that…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

Hey Jeremy, Typically with boat trailers the manufacturer will install hydraulic surge brakes because you don't have to worry about the water damaging wires like you would with electric brakes. That being said, if you use a heat shrink butt…

view full answer...

Answer 7

The Konig Tire Chains #TH01221102 (CB-12 102) and Konig Tire Chains #TH00023102 (CG-9 102) are virtually the same except that the #TH01221102 has assisted tensioning and the #TH00023102 is self tensioning. With the assisted tensioning you would have…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

Hey Vaughn, thanks for reaching out! The max psi rating of the Americana Aluminum Mod Trailer Wheel #AM22646 will be the equivalent to the rating of the valve stem that you install on it. The Americana Metal, Bolt-In Valve Stem #AM20906 can handle up…

view full answer...

Comparing the Level Sensor on the Curt Echo and Tekonsha Prodigy RF

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching