Voyager Trailer Brake Controller LED Light Does Not Turn Red with Brake Pedal and Sitting Still
Question:
The green light comes when i connect a test light to the blue wire. The truck is not moving. When i step on the pedal or activate the manual lever the light stays green No matter where the adjustments are. Is not moving the problem
asked by: Leroy
Expert Reply:
Actually, that is most likely the issue. The inertial sensor in the Voyager brake controller is not sensing any deceleration so it is not sending back voltage which means the light is not changing. I have included a link to the installation details for you. There is a troubleshooting section and not moving is the first cause listed when the red light does not come on.
Product Page this Question was Asked From
Tekonsha Voyager Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Manual Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- Indicator Lights
- Up to 90 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Q&A: Replacement Hub for Hammer Blow Hub Part HB732 on Old Trailer
- Q&A: Recommended Replacement for Atwood OD5001CW Direct Water Heater
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Most Concealed Hitch for a 2023 Subaru Ascent
- Q&A: How Do I Add a 7-Way Connector to a 2023 Subaru Ascent?
- Q&A: Replacement Motor For Power Gear Part 1510000006 On 2006 Fleetwood Fista
- Q&A: Replacement Water Heater for Atwood GC10A-3E
- Q&A: Replacement Thermostat for Dometic 3316410.012 Thermostat